Lenovo ThinkStation 4215 Hardware Maintenance Manual page 68

62
Hardware Maintenance Manual
Diagnostic Error Code
006-197-XXX
Diskette interface test warning
006-198-XXX
Diskette interface test aborted
006-199-XXX
Diskette interface test failed, cause unknown
006-25X-XXX
Diskette interface Error
011-000-XXX
Serial port Interface Test Passed
011-001-XXX
Serial port Presence
011-002-XXX
011-003-XXX
Serial port Timeout/Parity error
011-013-XXX
011-014-XXX
Serial port Control Signal/Loopback test
failure
011-015-XXX
Serial port External Loopback failure
011-027-XXX
Serial port Configuration/Setup error
011-03X-XXX
011-04X-XXX
Serial port failure
011-195-XXX
Serial port Test aborted by user
FRU/Action
1. If a component is called out, make sure
it is connected and/or enabled.
2. Re-run test.
3. Replace the component that is called out
in warning statement.
4. Replace the component under test.
1. If a component is called out, make sure
it is connected and/or enabled.
2. Flash the system and re-test. See
"Updating (flashing) the BIOS" on page
167.
3. Go to "Undetermined problems" on
page 81.
1. Go to "Undetermined problems" on
page 81.
2. Flash the system and re-test.
3. Replace component under function test.
1. Diskette drive cable
2. Diskette drive
3. System board
No action
1. Remove external serial device, if
present.
2. Run the Setup Utility program, enable
port.
3. System board
System board
System board
1. Wrap plug
2. System board
1. run the Setup Utility program, enable
port
2. Flash the system. See "Updating
(flashing) the BIOS" on page 167.
3. System board
System board
Information only
Restart the test, if necessary.