Service Interval Display; Service Interval Display - Skoda Rapid Owner's Manual

Note
If warning messages are displayed, these messages must be verified to access
■
the main menu » page 20, Using the information system.
If the display is not activated at that moment, the menu always shifts to one of
■
the higher levels after approx. 10 seconds.
Using the factory-fitted radio or navigation system
■
tions or» navigation system operating instructions.
Settings

First read and observe the introductory information and safety warn-
ings on page 25.
You can change certain settings by means of the MAXI DOT display. The current
menu item is shown in the top of the display under a line.
You can select the following menu options.
Language
You can set the language for the display texts here.
MFD data
Activate or deactivate certain displays of the multifunction display here.
Time
The time, time format (12 or 24 hour indicator) and the changeover between sum-
mer/winter time can be set here.
Winter tyres
Here, you can set the speed at which an audible signal should sound. This func-
tion is, for example, used for winter tyres where the maximum permissible speed
is lower than the maximum speed of the vehicle
rims.
The following message appears in the display when exceeding the speed limit:
Winter tyres: maximum ... km/h.
Units of measurement
The units for the temperature, consumption and distance driven can be set here.
1)
For models with the speedometer in mph, the second speed is displayed in km/h.
26
Using the system
» Radio operating instruc-

» page 168, Tyres and wheel
Alt. speed dis.
Here, the display of the second speed in mph
Service
Here you can have the remaining kilometres and days until the next service inter-
val displayed, and reset the Service Interval Display.
Factory setting
Here, the factory settings of the display can be restored.

Service Interval Display


Introduction
This chapter contains information on the following subjects:
Prompt in the segment display
Prompt in the MAXI DOT display
Before the next service interval is reached, a message concerning the kilometres
and days remaining until the next service is due is shown for about 10 seconds
after the ignition is switched on.
The kilometre indicator or the days indicator reduces in steps of 100 km or, where
applicable, days until the service due date is reached.
Note
Information is retained in the Service Interval Display even after the vehicle bat-
■
tery is disconnected.
If the instrument cluster is exchanged after a repair, the correct values must be
■
entered in the counter for the Service Interval Display. This work is carried out by
a specialist garage.
For more information on the service intervals, see
■
ter Service intervals.
can be activated.
1)
» Service schedule, chap-

27
27
