Samsung iDCS 500 General Description Manual page 69

LINE QUEUING WITH CALLBACK
When the desired outside line is busy, the user can press the CALLBACK key or
dial the access code to place his/her station in a queue. The user will be called
back when the line is available (a maximum of 100 callbacks are allowed system-
wide at one time including busy station and busy trunk).
LINE SKIPPING
When the user is talking on an outside line and the automatic hold feature is turned
off, he/she may press an idle line key and skip to that line without causing the
previous call to go on hold.
LOUD RINGING INTERFACE
The MISC daughter board has 3 relays that can be programmed to provide a dry
contact closure for control of a customer provided loud ringing device. Any of these
relays can be programmed to operate with a specific station or station group.
MANUAL SIGNALLING
Keysets can signal each other via a programmable key. This allows one station to
alert another without establishing a voice conversation. Each press of the key re-
sults in a 500 milliseconds of ring tone being set to the intended station. An indi-
vidual manual signaling key must be programmed for each station to be signaled.
MESSAGE WAITING LIGHT/INDICATION
When calling a station and receiving a busy signal or the no answer condition, the
caller can leave an indication that a message is waiting. The message button will
flash red at the messaged keyset. A single line phone connected to a 16MWSLI or
8MWSLI will have a message light otherwise it will receive a distinctive message
waiting dial tone. Five message waiting indications can be left at any station.
MUTE MICROPHONE/HANDSET
Any keyset user can mute the keyset's handset transmitter by pressing the MUTE
key. In addition, keyset users can also mute the keyset microphone while the keyset
is in speakerphone mode.
OFF-HOOK RINGING
When a keyset is in use, the system will provide an off-hook ring signal to indicate
that another call is waiting. The ring signal is a single ring repeated. The interval is
controlled by a system-wide timer. Single line stations will receive a tone burst
through the handset receiver instead of a ring.
OFF-HOOK VOICE ANNOUNCE (EXECUTIVE)
A keyset associated with an add-on module may receive an executive off-hook
voice announcement while on another call. The called keyset user may reply
handsfree without interrupting the call in progress. Only keysets with an off-hook
voice announce button (OHVA) can off-hook voice announce to keysets with AOMs.
(iDCS 500-L version software only)
4.35