Toshiba RAV-SM560AT-E Service Manual page 42

No. Item
5 Air speed
selection
(Continued)
Value in the parentheses indicates one when thermostat of
the remote controller works.
Value without parentheses indicates one when thermostat
of the body works.
• If the air speed has been changed once, it is not
• When heating operation has started, the air speed
• If the temperature is just on the difference boundary, the
• Mode in the parentheses indicates one in automatic
• In Tc ≥ 60°C, the air speed increases by 1 step.
3) In heating operation, the mode changes to [UL] if
4) If Ta ≥ 25°C when heating operation has started and
5) In automatic cooling/heating operation, the revolution
Outline of specifications
<HEAT>
Ta (˚C)
L(L)
(-0.5) –1.0
L(H)
(0) Tsh
H(H)
(+0.5) +1.0
H
(HH)
(+1.0) +2.0
HH
(+1.5) +3.0
(HH)
(+2.0)
+4.0
changed for 1 minute. However when the air speed is
exchanged, the air speed changes.
selects a upward slope, that is, the high position.
air speed does not change.
heating operation.
<Operation of duct only>
Standard High ceiling
COOL HEAT COOL HEAT
UL UL
L
L+ L
L+
M
M UL
M+ M+ L
H L+
H
M+,M M+,M
H
thermostat is turned off.
when defrost operation has been cleared, it operates
with HIGH (H) mode or (HH) for 1 minute from when Tc
has entered in E zone of cool air discharge preventive
control (Item 6).
frequency of [HH] is set larger than that in the standard
cooling/heating operation. However the revolution
frequency is restricted in the automatic heating opera-
tion as shown in the following figure.
E
D
C
B
A
SM560
Tap
Revolutions per
minute (rpm)
FD 320
FD 320
FB 330
FA 350
F9 360
UL F8 370
L F7 400
L+ F6 410
F5 420
F4 440
F3 480
F2 530
H F1 580
– 41 –
Remarks
SM800
320
Tc: Indoor heat exchanger
330
sensor temperature
340
360
370
380
410
440
450
480
500
540
580
[PRE-HEAT] display
Tc
(˚C)
47
42
F5 F4
F5