Toshiba RAV-SM560AT-E Service Manual page 184

4. Cord heater installation work procedure
No. Photo / Explanatory diagram
Remove each cabinet, inverter assembly, motor base assembly, and partition board assembly.
1
* Do not damage the electric parts such as cables, connectors, etc. while this work.
1-2 <Example for RAS-13JAVP-E>
Cord heater installation work
2 Drill a hole on the outdoor unit base, and fix the cord heater to the outdoor unit base using P-shape clamp.
Connect the cord heater cables.
2-1 Using a motor drill, etc., drill Ø3.2 holes to the existing emboss on the outdoor unit base. (12 positions)
As shown in the below figure, install the cord heater to the outdoor unit base by using P-shape clamp and screws
(Self-tapping screw type-B Ø4 × 6mm, stainless).
Pay attention to the direction of P-shape clamp so that it is set to the same direction in the left figure.
* If the drain port is frozen due to installation status, etc., draw around the cord heater so that the end part of the
heater is inserted into the drain port. In this case, add some fixing positions to fix the cord heater surely.
<RAV-SM560AT-E>
2-2
Heating part
* The end part from the marked part of the cord heater heats up. When there is the heating part near the electric
parts box, a fire may generate. Be sure to set the heating part on the outdoor unit base at the fan room side or
near it. (within 20cm from the outdoor unit base)
* Be careful that the cord heater does not hit the fan.
Fix the cord heater without any loosening or sag
As shown in the left figure, remove the set of refrigeration
cycle assembly from the outdoor unit base.
* In this time, work attentively so that the cycle pipes are
not damaged by dent or deformation. Apply protective
measures to pipes if necessary.
Enlarged
Heating part
marked part
Appendix-3
Procedure
<RAV-SM800AT-E>
Enlarged
marked part
Appendix