Table of Contents
Advertisement
DAILY MAINTENANCE:
(At the end of each working day):
1. Flush the entire system, including floor tool,
hand tool, etc., with 1 to 3 gallons of clean, hot
water.
2. Vacuum out the solution tank .
3. Rinse tank with fresh water. Periodically inspect
the recovery tank and decontaminate if
necessary, using a Hospital Grade Virucide or a
1-10 bleach to water solution. Waste water
should be disposed of properly.
4. Remove lint build-up from the float shut-off
screen in the recovery tank . (Occasionally
check filter screen at the bottom of the solution
tank and rinse clean with hot water if
necessary).
5. Inspect hoses for wear. Frayed or cracked
hoses should be replaced to avoid vacuum or
solution pressure loss.
6. Inspect power cord for wear or damage. This
cable will lay on wet carpet. To prevent
electrical shock replace cords that are frayed or
have cracked insulation immediately.
7. Ensure automatic shut-off ball is working
properly.
8. Clean all dirt and obstructions from drain valve
and gaskets to prevent possible leakage and
premature wear.
9. Run clean water through solution pump when
work is complete.
10. Empty both tanks and rinse, run vacuum (s) for
at least one minute to dry motor(s).
11. Store with access covers removed to allow tanks
to dry.
PERIODIC MAINTENANCE
1. Twice a month, flush a white vinegar solution
(One quart vinegar to two gallons of water) or
anti-browning solution (mixed as directed)
through the extractor, turning pump switch on/off
several times, flush with clean water. This will
prevent build-up of alkaline residue in the
system.
2. Check hoses for wear, blockages, or damage.
Frayed or cracked hoses should be repaired or
replaced to eliminate vacuum or solution
pressure loss.
3. Check all handles, switches, knobs, electrical
cables and connections on your machine for
damage. If the cable insulation is broken or
frayed, repair or replace it immediately. Don't
take chances with electrical fire or shock.
4. Clean out solution tank and remove and clean
solution screen.
5. Clean outside of all tanks and check for
damage.
MONTHLY MAINTENANCE
1. Check all bearings for noise and wear.
2. Check all gaskets for wear and leakage.
3. Check pump pressure; observe spray pattern
and check with gauge if necessary.
4. Check overall performance of machine.
5. Grease piston inside pressure regulator.
SEMI-ANNUALLY
1. Check vacuum motor brushes.
LUBRICATION
For hose fitting lubrication, use a light silicone
lubricant which will not damage o-rings.
STORAGE
Thoroughly clean machine if it is to be stored.
Protect this machine from freezing while in storage.
HEATER MODEL STORAGE
Be sure to thoroughly drain water out of heater lines
prior to storage in colder climates. This heater will
freeze and possibly crack, voiding your warranty.
D-250 86038570 05/11/07
MAINTENANCE
6
Advertisement
Table of Contents
