Ricoh G065 Service Manual page 148

SERVICE CALL CONDITIONS
SC Level
691 A GAVD FCI block I
An error is detected in the FCI
communication I
the GABIC2.
692 A CDIC GAVD block I
An error is detected in the CDIC
communication I
the GABIC2.
722 B Finisher jogger motor error
The finisher jogger H.P. sensor does
not return to the home position, or
move out of the home position, within
the specified time.
724 B Finisher staple hammer motor error
Stapling not complete within 600 ms
after the staple hammer motor turns
on.
725 B Finisher stack feed-out motor error
The stack feed-out belt H.P. sensor
does not activate within the specified
time after the stack feed-out motor
turns on.
726 B Finisher shift tray 1 lift motor error
• Tray shift does not finish within the
specified time after the shift motor
turns on
•
Stack height sensor does not
activate within the specified time
after the shift tray lift motor turns
on.
727 B Finisher stapler rotation motor error
The H.P. sensor does not switch on
or off within the specified time, i.e.
stapler rotation does not finish within
the specified time after the staple
rotation motor turns on, or the stapler
does not return to its H.P. within the
specified time after stapling finishes.
729 B Finisher punch motor error
After the punch motor turns on, the
punch H.P. sensor does not activate
within the specified time.
G065
CÓPIA NÃO CONTROLADA
Symptom
2
C bus error
2
C control register of
2
C bus error
2
C control register of
4-10
CÓPIA NÃO CONTROLADA
Possible Cause
• I2C bus on BICU defective
• I2C bus on BICU defective
• Jogger H.P. sensor defective
• Jogger motor defective
• Staple jam
• Stapler overload caused by trying
to staple too many sheets
• Staple hammer motor defective
• Stack feed-out H.P. sensor
defective
• Stack feed-out motor overload
• Stack feed-out motor defective
• Shift motor defective or
overloaded
• Shift tray lift motor defective or
overloaded
• Stapler rotation motor defective or
overloaded
• Stapler rotation motor connection
loose or connector defective
• Punch motor defective or
overloaded
• Punch H.P. sensor defective
• Punch motor connection loose or
connector defective
SM