Table of Contents
Advertisement
4. TROUBLESHOOTING
CAUTION
To avoid damaging the hard disk or memory, never turn off the main power
switch when the Data In LED is lit or flashing.
4.1 SERVICE CALL CONDITIONS
4.1.1 SUMMARY
There are 4 levels of service call conditions.
Level
To prevent damage to the machine, the main
machine cannot be operated until the SC has
A
been reset by a service representative (see the
note below).
If the SC was caused by incorrect sensor
B
detection, the SC can be reset by powering the
main power switch off and on.
The main machine can be operated as usual,
C
excluding the unit related to the service call.
The SC history is updated. The machine can be
D
operated as usual.
NOTE: 1) If there is problem with one of the electrical circuit boards, before
replacing the board, first disconnect then reconnect the connectors to
see if this solves the problem.
2) If the problem concerns a motor lock, first check the mechanical load on
the component before replacing motors or sensors.
SM
CÓPIA NÃO CONTROLADA
Definition
4-1
CÓPIA NÃO CONTROLADA
SERVICE CALL CONDITIONS
Reset Procedure
Enter SP mode, execute
SP5810, then exit the SP mode.
Turn the operation switch and
main power switch off and on.
Turn the operation switch off
and on.
The SC will not be displayed.
Only the SC history is updated.
G065
Advertisement
Table of Contents
