The 3G Backup Screen - ZyXEL Communications VMG5313-B30A User Manual

The following table describes the fields in this screen.
Table 9 Network Setting > Broadband > Add New WAN Interface/Edit (Bridge Mode)
LABEL
General
Active
Name
Type
Mode
VLAN
802.1p
802.1q
QoS
Rate Limit
Apply
Cancel

6.3 The 3G Backup Screen

The USB ports (at the left side panel of the VMG) allow you to attach a 3G dongle to wirelessly
connect to a 3G network for Internet access. You can have the VMG use the 3G WAN connection as
a backup. Disconnect the DSL and Ethernet WAN ports to use the 3G dongle as your primary WAN
connection. The VMG automatically uses a wired WAN connection when available.
Note: This VMG supports connecting one 3G dongle at a time.
Figure 21 Internet Access Application: 3G WAN
Use this screen to configure your 3G settings. Click Network Setting > Broadband > 3G
Backup.
Chapter 6 Broadband
DESCRIPTION
Select this to enable the interface.
Enter a service name of the connection.
Select ADSL/VDSL over PTM as the interface that you want to configure. The VMG uses
the VDSL technology for data transmission over the DSL port.
Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP's DHCP server directly. If you
select Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP server and
NAT on traffic from the selected LAN port(s).
This section is available only when you select ADSL/VDSL over PTM in the Type field.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame
that contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection.
The greater the number, the higher the priority level.
Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
Enter the rate limit for the connection. This is the maximum transmission rate allowed for
traffic on this connection.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
VMG5313-B10A/-B30A Series User's Guide
91