ZyXEL Communications VMG5313-B30A User Manual page 142

Click Apply to save your settings.
3
Figure 49 Network Setting > Home Networking > LAN Setup
The following table describes the fields in this screen.
Table 30 Network Setting > Home Networking > LAN Setup
LABEL DESCRIPTION
Interface Group
Group Name Select the interface group name for which you want to configure LAN settings. See
14 on page 205
LAN IP Setup
IPv4 Address Enter the LAN IPv4 IP address you want to assign to your VMG in dotted decimal notation,
for example, 192.168.1.1 (factory default).
Subnet Mask/ Type the subnet mask of your network in dotted decimal notation, for example
Prefix Length 255.255.255.0 (factory default). Your VMG automatically computes the subnet mask based
on the IP Address you enter, so do not change this field unless you are instructed to do so.
IGMP Snooping
Status Select the Enable IGMP Snooping checkbox to allows the VMG to passively learn multicast
group.
IGMP Mode Select Standard Mode to have the VMG forward multicast packets to a port that joins the
multicast group and broadcast unknown multicast packets from the WAN to all LAN ports.
Select Blocking Mode to have the VMG block all unknown multicast packets from the WAN.
DHCP Server State
DHCP Select Enable to have the VMG act as a DHCP server or DHCP relay agent.
Select Disable to stop the DHCP server on the VMG.
Select DHCP Relay to have the VMG forward DHCP request to the DHCP server.
DHCP Relay This field is only available when you select DHCP Relay in the DHCP field.
Server Address
IPv4 Address Enter the IPv4 IP address of the actual remote DHCP server in this field.
Chapter 8 Home Networking
for how to create a new interface group.
VMG5313-B10A/-B30A Series User's Guide
142
Chapter