Table of Contents
Advertisement
Getting started
Deskset installation (set static IP)
To set static IP when initially setting up the deskset:
Instructions on this page are for users to enter static IP to set up the
deskset, due to a failure in obtaining IP from the router automatically.
If you have successfully obtained the IP from your router, you do not
need to perform the steps below.
1.
If the deskset cannot obtain an IP address from the router after you power
it up, the screen displays No IP assigned. Check network, then displays
the network setup menu.
2.
Press
or
3.
The screen displays Enter static IP Use the dialing keys to enter a
specific IP.
•
Press DELETE to delete a character.
•
Press # to add a dot.
to add a dot. .
•
Press /REPEAT or /SKIP to move the cursor to the left or right.
When entering a specific IP, make sure the IP range is not blocked by
the router. If you are installing more than one deskset in the system, keep
the first three sets of digits consistent and the last one different among
different desksets. For example, if you enter 192.168.1.1 as the static IP
of the first deskset, make sure the first three sets of digits are also set as
192.168.1 in other system desksets.
4.
Press
SELECT. The screen displays Subnet mask: Use the dialing keys
MENU/
to enter a specific subnet mask.
•
Press DELETE to delete a character.
•
Press # to add a dot. .
•
Press /REPEAT or /SKIP to move the cursor to the left or right.
5.
Press
SELECT. The screen displays Router/Gateway: Use the dialing
MENU/
keys to enter a specific gateway.
•
Press DELETE to delete a character.
•
Press # to add a dot.
to add a dot. .
•
Press /REPEAT or /SKIP to move the cursor to the left or right.
6.
Press
SELECT to save. The screen displays IP obtained: XXX.XXX.
MENU/
XXX.X Please set an extension number to this phone.
7.
Press
SELECT. Press
MENU/
extension number.
8.
Press
SELECT to save. The screen displays Connected to Console
MENU/
(Console represents the name of the console) and then Starting... It takes
a while for the system to finish the startup. The deskset enters the idle
screen when the startup is done.
9.
Lift the handset. If you hear a dial tone, the installation was successful.
NOTE: Make sure the static IP you entered is not occupied by other network devices. You can
check the occupied IP addresses occupied in your router menu.
to scroll to Set static IP, then press
/REPEAT or /SKIP to choose the desired
MENU/
11
SELECT.
Advertisement
Table of Contents
