Advertisement
SA708 SPECIAL
FUNCTIONS
MULTI-FUNCTION OVENS
SPECIAL FEATURES FOR
MODEL SA708
The Smeg 70 cm wide oven model SA708 has
some special features:
ROTISSERIE GRILL OPTION:
The rotisserie grill operates on any cooking
function as long as the turn spit is fitted into
the drive motor. "B"
The rotisserie can be used with :
FAN GRILL
STATIC GRILL
FAN FORCED
\V°'J)
Use thermostat set
at 150-175°C
Use normal cooking temperatures, as described
in this manual.
ASSEMBLE TURN SPIT AS SHOWN
Insert rotisserie into drive motor "B" with
function controller set to 0 OFF position.
REMOVING THE DOOR SEAL
Clean in hot soapy water and replace.
INNER DOOR GLASS
It is possible to clean the inner door glass.
% The door should be removed from the oven.
/& loosen the screws "A" by two turns.
% firmly secure the door glass by holding it
on the lower and upper sides.
% Pull the panel "B" towards you evenly until
it is removed.
^
Clean in hot soapy water and replace.
NOTE: The glass must be repositioned with
the writing "D" legible, this means the reflec-
tive surface is facing the right direction.
REMOVING THE DOOR
The door on the SA708 oven removes slightly
differently to that described on Pg 7.
1. Open door fully
2. Remove the bottom of the oven door seal,
(fig 1)
3. Flip up the tab "B" on each hinge upwards until
they catch, letting the door rest on the tabs "B"
the door will remain adjar. (fig 2)
4. Hold the door firmly on both sides, close
slightly and lift up and towards you in order to
remove it from the oven.
REFITTING THE DOOR
To reposition the door, reverse the procedure.
1. Place the door onto the oven at about 30%
open, (fig 3)
2. Slip the left and right hinge arms into the
oven with the door square and level, so both
arms go in evenly.
3. Once inserted, open the door fully. Remove
and fold away the tabs "B".
4. Refit the door seal.
5. Close the door slowly to ensure there are no
problems.
Advertisement
