Table of Contents
Advertisement
Netware 2 - Wired Wall Control (Optional)
AUTO
SET CLOCK
MON TUE WED THU FRI SAT SUN
AM
PM
SET TIMER
SET CLOCK
TIME ACTIVATE
SLEEP
FAN
SWING
ON TIMER
CLOCK
DAY
HOLD
IM 820
SLEEP
SWING
DRY AUTO COOL HEAT FAN
COOL
˚F
TEMP.
ON
HEAT
TEMP.
OFF
˚C
ROOM
TEMP.
ON/OFF
MODE
SET TEMP
OFF TIMER
HOUR
MINUTE
Features:
1.
Modes - Cool, Heat, Auto, Dry, Fan and Off.
2.
Temperature Range - 60° F to 86° F. (Press both arrows
simultaneously to convert from °C to °F.)
3.
Timer - Seven day clock capable of a different On/Off
time for each day of the week. Note: Hold button is used
to temporarily override timer.
4.
Shows time of day.
5.
Electronic lockout to prevent tampering.
6.
Fan Speeds - Low, medium, high and auto.
7.
Sleep - Sets temperature back for sleeping.
8.
Swing - Swings or positions air baffle for better air dis-
tribution.
9.
Display normally shows room temperature. (Momen-
tarily shows set point when a change is made.)
10. Heat symbol (
) blinks while outdoor coil defrosts
(heat pump only).
11. Error codes blink on display:
E1 - Room sensor loose or defective.
E2 - Indoor coil sensor loose or defective.
E3 - Outdoor coil sensor loose or defective.
E4 - Compressor cycling on overload.
E5 - Low refrigerant charge.
For more detail, see manual that ships with the Wall Control.
Page 19
Advertisement
Table of Contents
