Remote Controller Operation Guide
Transmission source
•
The source where the signal is
transmitted.
Temperature Setting
•
Set the desired room temperature
by pressing the buttons to increase
or decrease the set temperature.
•
The temperature setting range is
from 60°F to 86°F.
•
Press both buttons simultaneously
to toggle the temperature setting
between °C and °F.
Fan Speed Selection
•
Press the button until the desired
fan option displays (auto, low,
med. or high). "Auto" automatically
selects high fan until room temper-
o
ature is within 2
F of setting, then
switches to low fan. Fan runs con-
tinuouse in COOL and cycles in
HEAT.
ON Timer Setting
•
Press the SET button will activate
the on timer function.
•
Set the desired on time by pressing
the SET button continuously. If the
timer is set to 7.30am, the air con-
ditioner will turn on at 7.30 sharp.
•
Press the CLR button to cancel the
on timer setting.
Automatic Air Swing
•
Press the SWING button to
activate the automatic air swing
function.
•
To distribute the air to a specific
direction, press the SWING
button and wait until the air
conditioner baffle swings to the
desired direction. Press the
button again to hold it.
Symbol Identification
Cool
Dry
Page 18
Clock Time Setting
•
Press button + or - to
increase or decrease the
clock time.
Heat
Fan
Signal Transmission Indication
•
On/Off Button
•
•
Operation mode
•
•
•
Sleep mode setting
•
•
•
Power
Sleep
Blinks to confirm the last setting
was sent to the unit.
Press once to start the air
conditioner.
Press again to stop the air
conditioner.
Press the MODE button to select
the type of operating mode.
For cooling only unit, the available
modes are : COOL, DRY & FAN.
For heat pump unit, the available
modes are: AUTO, COOL, DRY,
FAN & HEAT.
OFF Timer Setting
•
Press the SET button will activate
the off timer function.
•
Set the desired off time by pressing
the SET button continuously.
•
Press the CLR button to cancel the
off timer setting.
Press the button to activate sleep
mode. This function is available
under COOL, HEAT & AUTO mode.
In COOL mode, the set temperature
will increase 1.0°F after 30 minutes,
2°F after 1 hour and a total of 4°F
after 2 hours.
In HEAT mode, the set temperature
will decrease 2°F after 30 minutes,
4°F after 1 hour and a total of 5°F
after 2 hours.
Auto
Auto
Timer
low
med
high
Fan Speed
IM 820