Honeywell vx6 Reference Manual page 107

Message
Open failure
Open registry failure
Opened status file
Out of memory for
encrypted pwd
pRealTaskbarWndProc
already set
Pwd cancelled or invalid-
remain in user mode
Read registry error-hot
key
Read registry failure-app
name
Read registry failure-
Cmd Line
Read registry failure-
Internet
Registering Backdoor
MSG
Registering Hotkey MSG
Registry read failure at
reenter user mode
Registry read failure at
reenter user mode
Registry read failure
Reset system work area
failure
Shift pressed
Shift
Show taskbar
Explanation and/or corrective action
The status information is being saved to a file and the file open has failed. This
could occur if the file is write protected. If the file does not exist, it is created.
If the Administration registry key does not exist, the switch to user mode fails
because the AppName value in the Administration key is not available.
The status information is being saved to a file and the file has been opened
successfully.
Not enough memory to encrypt the password.
The taskbar control has already been installed.
The password prompt was cancelled by the user or the maximum number of failed
attempts to enter a password was exceeded.
The hotkey registry entry is missing or empty. This is not considered an error. The
keyboard hook uses an embedded default if the value is not set in the registry.
AppName registry value does not exist or is empty. This constitutes a failure for
switching into user mode.
AppCommandLine registry entry is missing or empty. This is not considered an error
since command line information is not necessary to launch and lock the application.
The Internet registry entry is missing or empty. This is not considered an error since
the Internet value is not necessary to launch and lock the application.
The AppLock system communicates with the keyboard hook via a user defined
message. Both AppLock.exe and Kbdhook.dll register the message at initialization.
The AppLock system communicates with the keyboard hook via a user defined
message. Both Applock.exe and Kbdhook.dll register the message at initialization.
The registry has to be read when entering user mode is the AppName is missing.
This user mode entry is attempted at boot and after a hotkey switch when the
administrator has closed the application being locked or has changed the
application name or command line.
The registry has to be read when switching into user mode. This is because the
administrator can change the settings during administration mode. The read of the
registry failed which means the Administration key was not found or the AppName
value was missing or empty.
The registry read failed. The registry information read when this message is logged
is the application information. It the Administration key cannot be opened or if the
AppName value is missing or empty, this error is logged. The other application
information is not required. If the AppName value is not available, AppLock cannot
switch into user mode.
The system work area is adjusted when in user mode to cover the taskbar area. The
system work area has to be adjusted to exclude the taskbar area in administration
mode. AppLock was unable to adjust this area.
The Shift key has been pressed and trapped by the HotKey processing.
Processing the hotkey and backdoor entry
The taskbar is now being made visible and enabled.
Level
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_ERROR
LOG_EX
LOG_EX
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_
PROCESSING
LOG_
PROCESSING
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_EX
LOG_
PROCESSING
3-55