4.9.2 Port Policing
This Page allows you to configure the Policer settings for all switch ports. The Port Policing screen in
The Page includes the following fields:
Object
•
Port
•
Enable
•
Rate
•
Unit
•
Flow Control
User's Manual of WGSW-20160HP/WGSW-24040HP series
Figure 4-9-1: QoS Ingress Port Policers Page Screenshot
Description
The port number for which the configuration below applies.
Controls whether the policer is enabled on this switch port.
Controls the rate for the policer. The default value is 500. This value is restricted
to 100-1000000 when the "Unit" is "kbps" or "fps", and it is restricted to 1-3300
when the "Unit" is "Mbps" or "kfps".
Controls the unit of measure for the policer rate as kbps, Mbps, fps or kfps . The
default value is "kbps".
If flow control is enabled and the port is in flow control mode, then pause frames
are sent instead of discarding frames.
191
Figure 4-9-1
appears.