Cable Strand Installation Hardware And Tools - Cisco Aironet 1550 Series Hardware Installation Manual

Warnings
•
•
•

Cable Strand Installation Hardware and Tools

To install the access point on a cable strand, you need the following additional parts:
•
•
•
Warnings
Translated versions of all safety warnings are available in the safety warning document that shipped with
your access point or on Cisco.com. To browse to the document on Cisco.com, refer to
"Translated Safety Warnings"
IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
This equipment is to be installed by trained and qualified personnel, as per these installation
Warning
instructions. The installer is responsible for obtaining any required local or national safety
inspections of the structural integrity of the installation by the local authority/inspection department.
Warning Do not operate the unit near unshielded blasting caps or in an explosive environment unless the
device has been modified to be especially qualified for such use. Statement 364
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
2-4
Two stainless steel mounting straps
–
Customer banding strap tool (BAND IT)—(AIR-BAND-INST-TL=)
Customer-supplied 13-mm and box-end wrench or socket set
Customer-supplied adjustable wrench, 22 mm socket, or Sealcon S-2200-WR socket wrench
Cable strand mount kit (AIR-ACCSMK1550=)
Four hex bolts (M8, 0x16mmL)
–
Four M8 split lock washers (0.14 8mmoD, 2mmT)
–
Four M8 flat washers (16.0mmOD, 1.6mmT)
–
Two carriage bolt fasteners (5/16-18 x 1.25 in.)
–
Six hex nuts, serrated flange (5/16-18)
–
Four carriage bolts (5/16 x 5/8LG)
–
– Strand mounting brackets—1 left bracket, 1 right bracket, 2 adjustable brackets
– Four strap clamps
Customer-supplied 13-mm box-end wrench or socket set
Customer-supplied adjustable wrench, 22 mm socket, or Sealcon S-2200-WR socket wrench
for instructions.
Chapter 2 Installing the Access Point
Appendix A,
OL-24247-01