Cisco Aironet 1550 Series Hardware Installation Manual page 67

Chapter 2 Installing the Access Point
Note
• Attach a ground wire.
Connect cables and power to the access point.
•
The access point must be installed on a cable strand by a professional cable installer.
Note
The 1552C access point can be installed using the pole mount kit in special circumstances. Refer to
Note
"Mounting the 1552C Access Point on a Pole/Wall" section on page 2-30
Access Point Facing Up in a Vault Application" section on page 2-33
To mount the access point, follow these steps:
Assemble the cable clamps to the clamp bracket on both cable brackets
Step 1
hand-tighten the nuts sufficiently to prevent them from falling off.
Figure 2-15
1
Secure each strap bracket with two M8 x16 bolts (with lock washers) on each side of the access point
Step 2
with the antennas facing down.
Nm).
OL-24247-01
The Low Profile Dual-Band 2.4/5 GHz Omni Antenna Array should already be attached to the
1552C or 1552E access points.
Assemble Cable Brackets
M8 flange nut and flat washer
(Figure
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
2
1
2 Cable Clamps
2-16). Only hand-tighten the bolts to 13 to 15 ft lbs (17.6 to 20.3
Installing the Access Point
or "Mounting the 1552C
for installation instructions.
(Figure 2-15). You should only
2-27