Upgrade Wizard On Setup Cd - THOMSON 716 User Manual

Chapter 6
Software Upgrade
Introduction
Starting the Upgrade
112

6.1 Upgrade Wizard on Setup CD

The procedures described in this section are valid only in case:
You run an Windows Operating System or Mac OS X.
Your SpeedTouch™ and computer are properly connected through Ethernet or
USB.
It is NOT possible to upgrade your SpeedTouch™ over a wireless
!
connection.
During the upgrade procedure in most cases configuration settings are backed up
by the wizard and restored after uploading the system software.
To launch the SpeedTouch™ Upgrade Wizard:
Wizard
Insert the Setup CD in your computer's CD-ROM or DVD-ROM drive. The
1
SpeedTouch™ CD menu will pop up automatically.
If not:
In the SpeedTouch™ CD Menu, click SpeedTouch Maintenance.
2
Click Upgrade My SpeedTouch, to start the SpeedTouch™ Upgrade Wizard.
3
See " Upgrade procedure" on page 113
4
In Windows:
Click Run on the Start menu and enter the following path:
D:\Setup.exe where D stands for the drive letter of your CD-ROM
or DVD-ROM drive.
On Mac OS X
Double-click the CD icon and then double-click Menu.
to continue.
E-DOC-CTC-20050803-0002 v2.0