Plumbing - Miele G 8066 Operating Instructions Manual

Plumbing

Connection to the water inlet
,
Water in the machine must not
be used as drinking water.
– The machine must be connected to
the water supply in accordance with
local and national water authority
regulations.
– This machine is constructed to
comply with German water
regulations (DVGW), and may be
connected to a suitable supply
without an extra non-return valve if
national regulations permit.
– The water pressure (flow rate) must
be a minimum of 1 bar (100 kPa).
If the water pressure (flow rate) is
below 1 bar (100 kPa), the filling time
is automatically extended.
The max. permitted static pressure is
10 bar (1000 kPa).
If the water pressure is not in the
range of 1 to 10 bar (100-1000 kPa)
the p / 6 indicator light may come
on and the fault code "F2E" show in
the display. Please contact the Miele
Service Department.
– The machine is supplied as standard
for connection to a cold or a hot wa-
ter supply up to a max. temperature
of 65 °C.
– A stopcock with 3/4 inch male thread
must be provided on site. It should
be easily accessible so that the wa-
ter supply can be turned off when
the machine is not in use.
56
– The DN 10 inlet hose is approx. 1.7
m long terminating in a 3/4 inch
female thread. A 1.5 metre long
flexible metal extension hose,
pressure tested to 140 bar, is
available as an optional accessory if
required. On no account may the
inlet filter be removed.
– A large surface area filter is enclosed
in the kit supplied with the machine
for installing between the stopcock
and the inlet hose (see the illustration
in "Cleaning the water inlet filter".
,
The inlet hose must not be
shortened or damaged in any way
(see illustration).
See also the installation diagram
supplied.