Problem Solving Guide - Miele G 8066 Operating Instructions Manual

Problem solving guide

With the aid of the following guide, minor problems can be easily corrected
without calling in a Miele service technician, saving you both time and money.
The following guide may help you to find the reason for a fault, and to correct it.
You should, however, note the following:
,
Repairs should only be carried out by a suitably qualified and trained
person in accordance with local and national safety regulations. Unauthorised
or incorrect repairs could cause personal injury or damage the machine.
Problem
The machine does not
start.
The dishwasher stops
during a programme.
A few minutes after
starting the programme,
the p indicator light
flashes (fault code F..E
appears in the display).
46
Possible cause
The door is not properly
closed.
The machine is not
connected to the
electricity supply.
The fuse has tripped.
The fuse has tripped.
The door is not properly
closed.
The stopcock is closed.
The water inlet filter is
blocked.
The Waterproof system
has reacted.
The water pressure at the
intake is lower than 100
kPa (1 bar).
Remedy
Close the door firmly.
Connect the machine to
the electricity supply.
Reset the fuse.
Reset the fuse.
Close the door firmly.
Open the stopcock fully.
Before rectifying the
problem you must:
– Switch off the machine
with the Z button.
Then:
– Clean the water inlet
filter, see "Cleaning the
water inlet filter".
Call the Miele Service
Department.
Seek professional advice.