Reports; Start-Up Report - Buderus 800 User Manual

7

Reports

7.1

Start-up report

 Please check off the start-up tasks carried out and enter the corresponding readings, while making sure that you carefully follow
the instructions.
Initial start-up tasks
1.Note down gas characteristics:
Wobbe index
Operational heat value
2.Has a leak test been carried out?
(see chapter 2.1.5 on page 24)
3.Check combustion air/flue gas connection
4.Check the boiler equipment (change to another type of gas if
necessary)(see chapter 2.2.1 on page 26)
5.Carry out adjustment settings
(see chapter 2.2.2 on page 27)
6.Measure the gas supply pressure (flow pressure)
(see chapter 2.2.3 on page 29)
7.Check and set the gas/air ratio
CO -content: under full load
2
under partial load
(see chapter 2.2.4 on page 30)
8.Check for leaks with system in operational condition
(see chapter 2.2.5 on page 31)
9.Record readings
Flow pressure
Exhaust-gas temperature, gross t
Air temperature t
L
Flue temperature, net t - t
A
Carbon dioxide (CO ) or oxygen (O
2
Exhaust-gas losses q
A
Carbon monoxide content (CO), free from air
(see chapter 2.2.6 on page 32)
10.Testing the operation
Measure the ionisation current
(see chapter 2.2.7 on page 32)
11.Fit the boiler casing
(see chapter 2.2.8 on page 33)
12.Instruct the user, hand over the documentation
(see chapter 2.2.9 on page 33)
13.Confirm commissioning (see Benchmark)
Confirmation of professional commissioning
(Company stamp, signature)
Wall-mounted condensing gas boiler Buderus 800 - Subject to modifications resulting from technical improvements!
A
L
) content
2
Remarks or measurement readings
kWh/m³
––––––––––––––––––––
kWh/m³
––––––––––––––––––––
mbar
––––––––––––––––––––
Pa
––––––––––––––––––––
%
––––––––––––––––––––
%
––––––––––––––––––––
Pa
––––––––––––––––––––
°C
––––––––––––––––––––
°C
––––––––––––––––––––
°C
––––––––––––––––––––
%
––––––––––––––––––––
%
––––––––––––––––––––
ppm
––––––––––––––––––––
µA
––––––––––––––––––––-
Reports 7
67