Quick Access To Information And Profile Selection Screens; Serial Number And Firmware Version Information - Laspaziale S1 Dream Owner's Manual

6 Quick Access to Information and Profile Selection Screens

6.1 Serial Number and Firmware Version Information

Dream GUI Addendum
S1 Dream Espresso Machine – GUI Addendum
Note that the word OFF in the lower left corner of the display is followed by
+1 in this photo. This means that the time listed below OFF+1 is for
tomorrow. If the display only showed OFF the time below would be for
today. (This is the same as OFF+0!) OFF+2 indicates the day after
tomorrow and so on. There are two ways to interpret this timer status display
which require that the user know how the machine was last turned on.
1. Dream is currently in a programmed ON cycle. In this case the time
displayed is the next programmed OFF time
2) Dream is currently in a programmed OFF cycle but was manually turned
on. In this case the time displayed is the next programmed ON time. In both
cases the number after OFF indicates which day the time is referring to.
If the programmable timer is disabled, the lower left corner will just display
the current time of day.
If the programmable timer is enabled but no times are programmed the timer
status will be displayed but the values are meaningless. Therefore, the
timer should also be set to disabled if all the times are deleted.
This photo shows a thermometer like icon the upper right corner
which indicates that the steam boiler is refilling. (Perhaps this icon is
actually supposed to be a vertical boiler!) The pump icon between
the group pressure and the time is also on as it is when pulling a
shot. This is how you can tell the difference between the pump being
on for a shot and the pump engaging to refill the steam boiler.
For about one minute after an alarm occurs you will see a
large description of the alarm on screen.
After an alarm has been active for one minute the descriptive text
goes away and is replaced by the alarm icon in the middle of the
screen. If you weren't looking at the screen when the above
message was displayed and you only see the icon in this photo, you
can go to a screen (see paragraph 6.2) and redisplay the text for this
alarm as well as for any other alarms that are currently active.
Page 7