Filter Replacement Notification - Laspaziale S1 Dream Owner's Manual

7.13 Filter Replacement Notification

This setting allows you to pick a number of gallons of water for your water filter so that you get an
alarm when it almost time to change the filters. This is a difficult option to test since even the smallest
programmable value takes a long time to hit. When this was last tested on an older ROM it actually
provided its notification when the value was down to ~20% of the total value rather than when it hit
zero. This is probably OK in a commercial environment where water volume is high and that last 20%
might go fast. In a home environment this is less useful. It is probably better to periodically check your
water hardness using test strips.
Dream GUI Addendum
S1 Dream Espresso Machine – GUI Addendum
When this screen is first displayed, it shows the current Service cycle count.
The current count is also shown in the status screens documented in
paragraph 6. Unfortunately, that fact is not shown in those screens since the
feature was disabled when those screenshots were taken. If you enter this
screen and do NOT want to reset to a new value (and lose the current
value), you have two options 1) Wait for a couple of minutes for the
operation to time out. This will completely exit the setup function and put you
back at the HOME screen.
In order to reset to a new value or 2) get an option not to change the value,
press the Menu button.
Use the Up and Down Arrow buttons to select the desired number of
service cycles. The press the Menu button to lock in this value and
return to Menu screen #2.
The options are:
5000, 2000, 1000, 500, and BACK. If you elect BACK and then
press Menu you return to Menu screen #2 without changing the
value and losing you current count. If you pick any other value the
service cycles is reset to this value when Menu is pressed.
With the large filter icon is displayed and the word
FILTER showing at the top of the screen, press the Menu
button.
Page 23