Table of Contents
Advertisement
6.5 Installing a modem
The installation of the MOD2000 modem is described below. The modem is provided with
a bracket for wall mounting. To install this bracket, please refer to Figure 3, Figure 7 and
Figure 34.
1.
Remove the protective cover from the double-sided self-adhesive tape on the rear-
mounting surface of the bracket supplied with the modem.
2.
Position the mounting bracket inside the fire panel as shown in Figure 3 and Figure 7
and fix it into position using the double-sided self-adhesive tape.
3.
Before connecting the modem to the fire panel ensure that the battery and the mains
power are isolated.
4.
Carefully read the Modem User's Manual. To connect the modem to the fire panel
and telephone line, refer to Figure 3, Figure 7 and Figure 34.
5.
Connect the green earth wire leading from the modem to the earth stud inside the
fire panel. Please note that the modem and associated circuitry are only protected if
this connection is made.
6.
Connect the power harness leading from the modem to the power supply. Observe
correct polarity. Please note that if the connector leading to the internal printer is not
used. It must be tied down using the mounting studs provided inside the fire panel.
7.
Connect the RS232 input on the modem to the serial port (DB-9 connector).
8.
Connect the telephone line to the modem protection board (use the telephone cable
adapter supplied if required).
9.
Slide the modem into the bracket inside the panel and fix all cables in position using
the hardware supplied (P-Clips and nuts). Ensure that the modem cannot slide out of
the bracket.
10. Restore battery and mains power to the fire panel and turn the modem power switch
the ON.
FP/FR1100/1200/2000 V6: Installation and Commissioning Manual
45
Hide quick links:
Advertisement
Table of Contents
