Turning Off The Server - Fujitsu Primergy RX600 S2 User Manual

Chapter 1 Overview

1.4.3 Turning Off the Server

1
Make sure that the CD-ROM drives are empty.
2
Shut down the OS.
When the OS is Windows or ServerView is installed, the server is turned off after the OS is shut
down (Step 3 is not necessary).
Make sure that the hard disk access LEDs are off when the OS is shut down.
3
Keep pressing the power switch on the front of the server for about three
seconds.
The server's power LED is turned off.
4
Turn off the display and peripheral devices.
The time to turn the server off can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView. For details, refer to
34
• Follow the procedures below to turn off the server. Data can be lost if
these procedures are not followed correctly.
• In the event of smoke or sparks, immediately unplug the electric cord.
Failure to do so could lead to a fire or electrocution.
System Power LED
System Power button
• Be sure to wait for 10 seconds or more after shutdown before turning the
server on.
"
3.2 Settings for Server Monitoring
The server's system
power LED is turned off.
" "
in ServerView User's Guide.
"