Fujitsu Primergy RX600 S2 User Manual page 263

Error
Message
Code
8420 Intelligent System Monitoring Chassis
Opened
84F2 Baseboard Management Controller
failed to respond
84F3 Baseboard Management Controller in
Update Mode
84F4 Sensor Data Record Empty
84FF System Event Log Full
8500- Board: n, DIMM: n Memory bad or
85DB missing
Board: n, DIMM: n Memory not
configured
Board: n, DIMM: n Memory disabled
Board: n, DIMM: n Memory mismatch
Board: n, DIMM: n Memory
correctable ECC error
Board: n, DIMM: n Memory
uncorrectable ECC error
Board: n, DIMM: n Memory invalid
speed
85E0 Board: n Memory bad or missing
85E8
85F0
85F8
85E1 Board: n Memory not configured
85E9
85F1
85F9
85FC System Memory bad or missing
table: List of POST Errors
Baseboard error. The baseboard must be replaced.
Contact an office listed in the "Contact Information" of
"Start Guide".
The writing area for the system event log is full. Remove
older system event logs. If the message still appears after
clearing the system event logs, the baseboard must be
replaced. Contact an office listed in the "Contact
Information" of "Start Guide".
Memory error ("n" in the message represents the memory
board/slot number). Check that the memory is mounted
properly. If the message appears although the installation
is correct, replace the memory. If the message still
appears, replace the memory board. If the message still
appears after the replacement, the baseboard must be
replaced. Contact an office listed in the "Contact
Information" of "Start Guide".
Memory error ("n" in the message represents the memory
board/slot number). Check that the memory is mounted
properly. If the message appears although the installation
is correct, replace the memory. If the message still
appears, replace the memory board. If the message still
appears after the replacement, the baseboard must be
replaced. Contact an office listed in the "Contact
Information" of "Start Guide".
The installation configuration of the memory is wrong
("n" in the message represents the memory board/slot
number). Confirm the memory configuration and the
information on the installed memories using the BIOS
Setup Utility. If the message appears although the
installation is correct, replace the memory. If the message
still appears, replace the memory board. If the message
still appears after the replacement, the baseboard must be
replaced. Contact an office listed in the "Contact
Information" of "Start Guide".
System memory error. Check that the memory is mounted
properly. If the message appears although the installation
is correct, replace the memory board. If the message still
appears, replace the memory. If the message still appears
after the replacement, the baseboard must be replaced.
Contact an office listed in the "Contact Information" of
"Start Guide".
PRIMERGY RX600 S2 User's Guide
Description
9
263