Update Display; Send Settings To Cutter: Temporary; Send Settings To Cutter: Permanent - Ioline SmarTrac I/S Series User Manual

Tag Board Tag Board Cutout is for cutting stencil material (tag board).
Cutout A standard blade holder and blade is required. An in-
termittent cut is created so that the stencil stays in place
during cutting. See Cut and Blank below for more details.
Cut The Cut value is the length, in thousands of an inch
(mils.), that the blade will cut when plotting the segment-
ed line for pouncing or tag board cutout.
Default Length
Maximum Length
Minimum Length
Blank The Blank value is the length, in thousands of an inch
(mils), that the blade skips (e.g. will not cut) when plot-
ting the segmented line for pouncing or tag board cutout.
The default length is 600 mils (.6 inches) for pouncing
and 60 mils for tag board. The maximum is 4000 mils for
pouncing and 5000 mils for tag board. The minimum is 40
mils for pouncing and 50 mils for tag board.
Default Length
Maximum Length
Minimum Length

Update Display

Selecting this option will update all of the screen values with the cur-
rent settings stored in the cutter. For example, using Update Display
after a blade is inserted in the carriage will update the Control Cen-
ter and allow access to the Tag Board Cutout parameters.

Send Settings to Cutter: Temporary

After changing any setting, the changes must be sent to the cutter. If
Send Settings to Cutter: Temporary is selected, all of the displayed
settings will be used for the current session. When the cutter is
turned off these settings will be lost and the previous permanent
settings will be in effect when the cutter is turned on again. If any
settings are changed, repeat the Test Cut procedure to ensure that
the results are satisfactory.

Send Settings to Cutter: Permanent

If Send Settings to Cutter: Permanent is selected, all of the displayed
settings will be sent to the cutter and will be saved for all subsequent
sessions, even after turning off the cutter.
Pouncing Tag Board
40 mils. (.04-in) 2000 mils.
4000 mils. 5000 mils.
40 mils. 50 mils.
Cut Values
Pouncing Tag Board
600 mils. (.6-in) 60 mils.
4000 mils. 5000 mils.
40 mils. 50 mils.
Blank Values
Chapter 2: Operation
i
Note
The design software may override
the Control Center settings.
Check to see if it has by pressing
the Update Display button be-
fore and after a cut is completed.
Check the plotter setup screens
in the design software to make
adjustments if necessary.
27