Install Ioline Software, Drivers And Manuals; Power On; Install Drivers - Ioline SmarTrac I/S Series User Manual

Install Ioline Software, Drivers and Manuals

The Control Center is a utility that enables you to adjust parameters
and optimize cutter performance. The SmarTrac and 100 System
come with a CD-ROM that includes a Microsoft Windows
and Win 7 version of the Ioline Control Center, the 101 software
(100 System only), USB drivers, Adobe Acrobat, and electronic User
Guides (Acrobat required to view).
1. Turn on the power to the computer and start Windows
2. Insert the Ioline CD ROM into the CD ROM drive (usually D:)
3. Select the Start button.
4. Choose Run.
5. Type D:\SETUP (substitute the correct letter if the CD ROM
drive letter is not D:) and Click OK.
6. Follow the instructions that appear on the screen.
7. Consult the Operation chapter of this manual for details on us-
ing the Ioline Control Center software.

Power On

1. Turn on power to the Ioline equipment. The cutter power
switch is located next to the power cord behind the keypad.
2. The carriage will move toward the keypad side of the machine
when the power is turned on. Keep hands and loose clothing
away from all moving parts of the cutter.
3. The red LED on the front panel will light when the start-up
process is finished.

Install Drivers

1. After power on, USB driver installation should start automati-
cally.
2. A warning may appear about driver certification. Click "Ok",
"Proceed Anyway," or "Continue."
Figure 7. Ignore the Windows
XP, Vista
®
.
®
XP Warning.
®
Chapter 1: Overview
i
Note
Ioline USB drivers are only com-
patible and tested with Microsoft
Windows operating systems ver-
sions XP, Vista, and Win 7.
i
Note
Ioline USB drivers create a special
COM port that allows computer
software with serial communi-
cation support to use the USB
connection.
17