Section 8: Installing The Accessories; Installing The H38Df Log Set - Montigo H38DF Installation & Maintenance Manual

Installing the Log set:
The H38DF* is supplied with a six ceramic fibre log logset. Unpack the
logs and handle them very carefully.
Step 1. Remove the glass door as described in the previous Instructions.
Rear / Bottom Log
Log A
Pilot Assembly
Air Inlets
Notch in Log
Fireplace Base
Figure 27a. Bottom Rear Log, (Log A).
Step 2. Place the bottom Rear log (Log A) as shown in figure27a.
Log C
Fireplace Base
Figure 27b. Left front Log, (Log C) and Right front Log, (Log B).
Step 3. Place the bottom Right log (Log B) and bottom Left Log, (Log
C) as shown in figure 27b.
Log D
Fireplace Base
Figure 27c. Top Left Log, (Log D).
Step 5. Place Front Left log (Log D) as shown in figure 27c.
XG0147 - 042811
Installation
Log B
Air Inlets
Air Inlets

Section 8: Installing the accessories

Air Inlets
Fireplace Base
Figure 27e. Top Right Log, (Log E)..
Step 6. Place Front Right log (Log E) as shown in figure 27e.
Log F
Fireplace Base
Figure 27f. Front Left Log, (Log F).
Step 7. Place Front Left log (Log F) as shown in figure 27f. Set notch
in lower end of Log F against stile on Log Grate.
Figure 27g. Completed Logset.
XW2044
H*38DF Gas Fireplace
Log E
NOTICE
If logs are not placed properly, excessive
sooting will result.
Page 21