Enter Program Mode; Recall Defaults - Metrologic IS4320 ScanGlove Programming Manual

Enter/Exit Program Mode

Enter Program Mode

When this option is selected, enter
**Ability to Enter Program
Mode After Any Scan programming by scanning the
ENTER/EXIT PROGRAM MODE bar
code after power up or during normal
scanning operation.
R 1 8
When this option is selected, the scanner
Enter Program Mode Only
on First Scan will only enter program mode after power-
up. Scan the ENTER/EXIT PROGRAM
MODE bar code immediately after the
scanner first receives power. This option
R 1 9
prevents the scanner from accidentally
entering program mode during normal
scanning operation.

Recall Defaults

If during programming of the scanner, there is a need to return the scanner to
the original factory settings, scan the RECALL DEFAULTS bar code. Any
settings selected during that session or any previous session will be lost .
2
* *
Recall Defaults
D F 1