Enter/Exit Program Mode
RS-232 Parameter - Hardware Handshaking
To prevent scanned information from being lost during
transmission, your host device may require an RTS/
CTS signal. When RTS/CTS (Ready To Send/Clear To
Send) enables, the scanner will output an RTS signal
and wait for a CTS signal before any data transmits. The
default setting of RTS/CTS disables. If necessary, scan
the ENABLE RTS/CTS bar code.
When this option is selected, the scanner will
** Character RTS/CTS
activate and deactivate its RTS signal on each
character that it transmits.
R
5
6
When this option is selected, the scanner will
Message RTS/CTS
activate and deactivate its RTS signal on each
message that it transmits. This mode should
normally enable for Sanyo registers.
R
5
7
12
*
*
Enable RTS/CTS
H
H
1
** Disable RTS/CTS
H
H
2