Programming The Scanner - Metrologic IS4320 ScanGlove Programming Manual

Programming the Scanner

The IS4320 is shipped from the factory programmed to a set of default
parameters. Defaults are noted in the following pages by double asterisks next
to the bar code labels. Modifications to the default program to match the host
system are made using bar codes contained in this manual.
1. Connect the scanner to the host system or power source. (Refer to the
Installation and User's Guide.)
2. Scan the ENTER/EXIT PROGRAM MODE bar code. (The unit will
beep three times.)
3. Scan by positioning the output window within two inches of each code.
(When you scan the first menu selection, the laser will stay on until you
scan the ENTER/EXIT PROGRAM MODE code again. If no scanning
occurs for 30 seconds while the scanner is in program mode, the unit
will beep three times and all changes made will be lost. If this occurs,
return to Step 1.)
4. After completing the scanning of the appropriate configuration options,
scan the ENTER/EXIT PROGRAM MODE bar code again. (The new
options will be saved and the scanner is ready for normal operation.)
Program Mode
Enter/Exit
* *
1