Table of Contents
Advertisement
Enter/Exit Program Mode
Test Modes
Scan Count
When scanning this option, the scanner
will enter the scan count test mode. The
firmware number of the scanner will also
transmit to the host device. Do not enable
S
M
3
this feature unless a Metrologic
representative instructs you to do so.
When this option is enabled, the scanner
Scannability
will enter the scannability test mode. Do
not enable this feature unless a Metrologic
representative instructs to do so.
S
M
2
When this option is selected, the scanner
Normal Scan
will exit from the scannability or scan
count test modes.
S
M
1
When this option is selected, the scanner
Transmit Scanner Parameters
will transmit (at 9600 baud) its current
configuration.
I
B
6
34
*
*
Advertisement
Table of Contents
