Table of Contents
Advertisement
Level 2 Service Manual
Removing and Replacing the Vibrator/Flex Assembly
6809507A01-O
1.
Remove the battery cover, battery, antenna, rear housing, transceiver board,
keypad, flip assembly, flip lens flip cover, flip assembly shield and display PC
board, as described in the procedures.
2.
Use the disassembly tool to disconnect the flex from the camera PC board
assembly.
Figure 21. Removing the Vibrator/Flex Assembly
3.
Remove the barrel bushing, and then carefully remove the vibrator/flex
assembly from the opening in the flip housing.
Figure 22. Removing the Vibrator/Flex Assembly
4.
To replace, carefully slide the vibrator/flex assembly through the opening in
the flip housing, attach the barrel bushing, and press the flex onto its connector.
5.
Replace the display PC board, flip assembly shield, flip cover, flip lens, flip
assembly, keypad, transceiver board, rear housing, antenna, battery, and
battery cover as described in the procedures.
October 02, 2006
Flex Connector
Barrel bushing
Disassembly
Disassembly Tool
050871o
061283o
35
Advertisement
Table of Contents
