JVC HR-S9400EE Instructions Manual page 33

1
4
7
:VPS
Satellite Tuner Users
To timer-record a satellite broadcast using Regular Timer
Programming:
Before you start step 1, be sure to set the recorder's input
mode to "AUX2" ( pg. 39). Do NOT change the input
mode until the selected programme has been timer-
recorded. In step 6, you have to select "AUX2" as well.
Before the selected programme begins, select the
appropriate channel on the satellite tuner, and then set
the tuner's timer. If your satellite tuner does not have a
timer, leave the unit's power on.
2
2 3
6
5
WEEKLY
8 9
TIMER
0
4
TV PROG+/–
OK
ENTER CHANNEL POSITION
6
Press TV PROG +/–.
SP
IMPORTANT
Be sure to confirm the setting of VPS recording.
If " ON" is displayed on the screen or "
on the display panel, VPS is set to ON.
If " OFF" is displayed on the screen or "
not lit on the display panel, VPS is set to OFF.
To change the setting, press
"7").
"VPS Recording" on page 35.
SET TAPE SPEED
7
Press (SP/LP) to set the tape speed.
RETURN TO NORMAL
SCREEN
8
After confirming all information is correct, press OK
and the normal screen appears.
Repeat steps 1–8 for each additional programme.
ENGAGE RECORDER'S
TIMER MODE
9
Press TIMER. The recorder turns off automatically.
To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 8, press WEEKLY (NUMBER
key "9") for weekly serials or DAILY (NUMBER key "8") for
daily serials (Monday–Friday). Either "WEEKLY" or "DAILY"
appears on the screen. Pressing the button again makes the
corresponding indication disappear.
NOTE:
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, "PROGRAM FULL" appears on screen. To record the
extra programme, you must first cancel any unnecessary
programmes ( pg. 34).
33
EN
– P1 –
START STOP
=
21:00 22:00
SP ON
DATE TV PROG
25.12 1
[+/–] =
[MENU] : EXIT
" is lit
" is
: VPS (NUMBER key