Index Search; Instant Review; Repeat Playback - JVC HR-S9400EE Instructions Manual

Index Search

Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.
NOTE:
Before starting, make sure the
recorder is in the Stop mode.
ACTIVATE INDEX SEARCH
1
Press PUSH JOG
control. "™ 1" or "£ 1" is displayed on screen
and search begins in the corresponding direction.
To access index codes 2 through 9, press PUSH JOG
or repeatedly until the correct index number is
displayed.
Ex.: To locate the beginning of B from the current
position, press PUSH JOG twice.
To locate the beginning of D from the current
position, press PUSH JOG
A
–2
When the specified index code is located, playback
begins automatically.

Instant ReView

Simply by pressing a single button, the recorder power comes
on, rewinds, and begins playback of the last timer-recorded
programme. If you have several programmes recorded, you can
easily access any of them.
NOTE:
Before starting, make sure that the recorder is off and that the
Timer mode is disengaged.
ACTIVATE INSTANT
REVIEW
1
Press REVIEW. The recorder power comes on and the
recorder searches for the index code indicating the start
of the last timer-recorded programme. Once it's found,
playback begins automatically.
The front display panel tells you how many programmes
have been recorded. If you have, for example, 3
programmes, "REVIEW" and "3" appear and blink. To
watch the first of the 3 programmes, press REVIEW three
times. The recorder searches and begins playback
automatically. You can access a programme as far as 9
index codes away from the current tape position.
NOTE:
Instant ReView is not possible while the recorder is in the Timer
mode.
or (™ or £) on the remote
once.
Current position
B C D E F
–1 1 2 3
Index number
MESECAM Playback
Your recorder is equipped with MESECAM circuitry that can
£ 2
play back MESECAM tapes. MESECAM is the designation for
tapes with SECAM signals that have been recorded on a
MESECAM-compatible PAL video recorder.
LOAD A CASSETTE
1
Insert a cassette recorded in MESECAM.
ENGAGE MESECAM PLAYBACK
MODE
2
Press MESECAM PLAY-
BACK; the current setting
will be displayed on the
screen for about 5 seconds.
Pressing MESECAM
PLAYBACK while the
screen shows the display
changes the setting.
The setting will remain
effective even though
you turn on/off the recorder or you insert/eject the
cassette.
The setting cannot be changed during search, still,
frame-by-frame playback or slow motion mode.
START PLAYBACK
3
Press PLAY.
NOTES:
You can change the "MESECAM P.B." setting even though
"O.S.D." is set to "OFF".
When you play back a PAL or SECAM tape, be sure to set
"MESECAM P.B." to "OFF".

Repeat Playback

Your video recorder can
automatically play back
the whole tape 20 times
repeatedly.
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
The Play indicator ($) on the display panel blinks
slowly.
The tape plays 20 times automatically, and then
stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.
17
EN
MESECAM P.B. ON