Table of Contents
Advertisement
F
INISHING THE
Step 1. Tuck connections neatly into ceiling outlet box.
Step 2. Slide the canopy up to mounting bracket and place the
key hole on the canopy over the screw on the mounting
bracket, turn canopy until it locks in place at the narrow
section of the key holes.
Step 3. Align the circular hole on canopy with the remaining
hole on the mounting bracket, secure by tightening the two
set screws. Note: Adjust the canopy screws as necessary until
the canopy and canopy cover are snug.
WARNING:
WARNING: Make sure the hook on the hanging bracket
properly sits in the groove in the hanger ball before attaching
the canopy to the bracket by turning the housing until it
drops into place.
B
A
LADE
TTACHMENT
CAUTION: Remove 5 rubber packing mounts from fan
CAUTION:
motor assembly and discard before installation.
1. Place rubber washer on screw. Insert this assembly
through the blade and start the screw into the blade arm.
Repeat this procedure without tightening the screw until
all 3 screws have been started into the blade arm.
NOTE: Fans that have painted finishes are packed with
NOTE:
gaskets that can be used between the blade arm and blade
to help prevent a clicking noise that may develop if blade
screws loosen over time.
2. Tighten each screw starting with center screw.
3. Fasten blade assembly to motor with provided screws
and lockwashers. Repeat procedure for remaining blades.
Make sure screws are TIGHT!
contribute to unnecessary hum during operation.
NOTE:
NOTE: Cordless power screwdrivers are NOT
as they tend to strip the heads of the screws and usually will
not fully compress the lock washers on the motor screws. Use
a large flat blade screwdriver for final tightening to fully
compress the washers. This will help ensure proper alignment
of the blades and noise-free, wobble-free running.
I
NSTALLATION
TIGHT! Loose motor screws can
NOT recommended,
Hanging
Bracket
Canopy
Canopy Screw
Cover Plate
Screws
8
Ceiling Fan
Outlet Box
Screws
Screws
Rubber
Washers
Blade Arm
Install gasket between
blade arm and blade
(optional)
Advertisement
Table of Contents
