Regency ANDROS Owner's Manual page 6

I
NSTALLING THE
1. Carefully support fan body (motor) in its styrofoam
packing with the mounting collar (where the wires come
out) facing upward.
2. Loosen the two set screws and remove the downrod pin
and cotter pin from the top coupling of the motor
assembly. (Fig. 1)
3. Remove ball from the downrod by loosening set screw in
the side of the ball. Slide ball down and remove ball pin;
remove ball.
4. Feed the wires from top of fan through end of the downrod
of choice and set end of downrod into mounting collar so
the hole in the downrod lines up with the hole in the side
of the mounting collar.
5. Insert downrod pin through holes in mounting collar and
downrod; slip cotter pin through small hole in end of
downrod pin to hold downrod in place.
6. Tighten jam screws against downrod using a large flat
blade screwdriver to ensure a tight fit against downrod.
Tighten nuts against mounting collar.
NOTE: NOTE: Fan has 6 feet of hook-up wire in case you are using
a long extension downrod. Wires can be cut so only 8
inches or so extend beyond the top of the downrod to make
the electrical connections easier and safer.
7. Feed wires through collar cover and slide collar cover
down the downrod to top of fan.
8. Feed wires through canopy screw cover plate and
canopy, then slide both over downrod to lay on top of
collar cover. It will be attached to ceiling later.
9. Feed wires through ball and slide ball over downrod, past
hole in the top end of the downrod. Insert ball pin
(removed in step 3), slide ball up, and tighten set screw
to secure ball in place.
10. Lift ball/downrod/fan into hanging bracket opening.
NOTE:
NOTE: The tab opposite hanging bracket opening should fit
in slot on ball.
F
AN
Ball
Canopy
Downrod
Mounting Collar
Downrod Pin
Top of
Fan Body
Fig. 1
Slot
Fig. 2
5
Hook-up (3)
Wires
Ground
Wire
Canopy Screw
Cover Plate
Collar Cover
Security Screws
Cotter
Pin
Tab