Table of Contents
Advertisement
E
C
LECTRICAL
WARNING:
WARNING: To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring.
Multiple code choices are included with your fan¡¦s remote control in case:
* you have more than one remote control fan and want them to respond only to their own remote control.
* you have other radio controlled devices in your home that may interfere with the fan remote control. (i.e. garage
door opener)
* you experience radio interference on a chosen frequency. (code setting)
* do not use factory codes, change to new settings.
NOTE: This remote control unit is equipped with 16 code combinations to prevent possible interference from or to
NOTE:
other remote units. The frequency switches on your receiver and transmitter have been preset at the factory. Please
recheck to make sure the switches on transmitter and receiver are set to the same position, any combination of settings
will operate the fan as long as the transmitter and receiver are set to the same position. (Fig. 1)
Step 1. (Fig. 2) Insert the receiver into the mounting bracket with the flat side of the receiver facing the ceiling.
Step 2. (Fig. 3) Motor to Receiver Electrical Connections: Connect the black wire from the fan to black wire marked
"TO MOTOR L". Connect the white wire from the fan to the white wire marked "TO MOTOR N" from the receiver.
Connect the blue wire from the fan to the blue wire marked "For Light" from the receiver. Secure the wire connections
with the plastic wire nuts provided.
Code switch
ON
ON
Fig. 1
ONNECTIONS
Receiver
Fig. 2
6
Hanging
bracket
Advertisement
Table of Contents
