STABILIZER SHAFTS
Refer to Fig. 3D-9, 3D-10 and 3D-11 for specific rear
stabilizer shaft mounting on C and P models.
Replacement
1. Raise vehicle on hoist and support rear axle.
2. Remove nut, washer and grommet from link bolt
at the frame side member on each side.
3. Withdraw link bolt, washers, grommets and spacer.
Fig. 3 D -7 -S h o c k A bso rb er-P -10, 2 0
REAR SUSPENSION
Fig. 3D-8~Shock Absorber-P30
4. Remove brackets from anchor plates by removing
attaching screws.
5. Remove stabilizer shafts.
6. Reverse above steps to install stabilizer shaft. On
installation, position shaft so parking brake cable is routed
over stabilizer.
7. Torque all bolts to specifications.
See NOTICE on page 1 of this section,
NOTICE:
regarding stablizer fasteners.
8. Lower hoist and remove vehicle.
3D-3
LIG H T T R U C K S ER V IC E M AN U AL