Chevrolet 1980 Light Duty Truck Service Manual page 110

2B-2 BUMPERS
Installation
Install rear step bumper by reversing removal
procedure. Connect license lamp wiring.
FRONT BUMPER ■ G MODELS
Removal Fig. 2B-5, 2B-6
1. Remove nuts securing bumpers to brackets and
braces from left and right side. Remove bumper.
2. If necessary to remove the braces and brackets,
remove screws securing brackets and braces to sheet metal.
3. If equipped with bumper guards (Fig. 2B-6) they
may be removed from the face bar at this time.
Installation
Reverse removal steps to install bumpers.
REAR BUMPER-G MODELS
Removal Fig. 2B-7, 2B-8
1. Remove nuts securing bumper to brackets and
Fig. 2B-4--Rear Step Bumper C and K Models
braces and remove the bumper.
2. Remove the license plate support nut and bolts.
3. Remove brackets and braces from vehicle.
The bumper may be removed with brackets and braces
attached if necessary.
Installation
Install in reverse order of removal.
Fig. 2B-5--Front Bumper - G Models
.160/.180
(CLEARANCE)
LIG H T T R U C K S E R V IC E M AN U A L