Chevrolet 1980 Light Duty Truck Service Manual page 242

3B 4-28 STEERING CO LU M N S
SHIFT GATE
THRUST
CUP
Fig. 3B4-43--Turn Signal Housing Assembly
Fig. 3B4-44--Removing Ignition Switch Actuator Sector
13. Install the neutral-safety or back-up switch as
outlined in Section 8 of this manual.
14. Slide the steering shaft into the column and install
the upper bearing thrust washer.
15. Install the turn signal switch, lock Cylinder
assembly and ignition switch as previously outlined in this
section.
16. Install the shift lever and shift lever pivot pin.
17. Remove the column from the vise.
18. Install the dash bracket to the column; torque the
screws to specifications.
RACK
LOCK BOLT
LOCK BOLT
SPRING
SECTOR
Fig. 3 B 4 -4 7 --ln s ta llin g G earshift Housing Low er Bearing
Fig. 3B4-45~Removing Lower Bearing Retainer
Fig. 3B4-46~lnstalling Rack Preload Spring
LIG H T T R U C K S E R V IC E M ANUAL