Chevrolet 1980 Light Duty Truck Service Manual page 139

14. Remove screw locking sector gear in a fixed
position.
15. Insert regulator into door in such a position that
motor connector can be installed onto motor.
16. Reinstall regulator into door.
LOCKS, HANDLES AND RODS
Door Lock Assemb!y--Fig. 2D -36
Replacement
1. Raise window to full up position.
2. Remove trim panel as outlined in this section.
3. Remove clip from inside handle rod-to-lock.
4. Remove clip from outside handle rod-to-lock.
5. Remove screws which attach lock assembly to door
panel.
6. Remove lock and remote control rod as an
assembly.
7. To install lock assembly, reverse above steps. Be
sure to replace all clips removed earlier.
Door Outside Handle--Fig. 2D-37
Replacement
1. Raise window to full up position.
2. Remove trim panel as outlined.
3. Remove clip from outside handle rod-to-lock.
4. Remove screws which retain outside handle to door
panel.
5. Remove handle and control rod.
6. Reverse above procedures to install outside handle.
Fig. 2 D -37 ~ O u ts id e Handle and Lock Cylinder
Door Lock Cylinder -Fig 2D-37
Replacement
1. Raise door window.
2. Remove trim panel as outlined.
3. Use a screwdriver or other suitable tool to slide the
lock cylinder retaining clip out of engagement with the lock
cylinder.
4. Remove lock cylinder.
5. To install, reverse the above steps.
Door Inside Handle
Replacement
1. Remove trim panel as outlined.
2. Disconnect control rod from inside handle, as
shown in figure 2D-38.
3. Remove screws retaining inside handle to door.
4. Remove inside handle.
5. Reverse above steps to install.
BODY 2D -15
LIG H T T R U C K S ER V ICE M ANUAL