NOTE
Full range of gap
tolerances do not apply to
any one gap. Clearances to
be held uniformly within the
range of good assembly
practices. Appearances
dictate that gap clearances
should be parallel.
COWL TO HOOD
.18 ± .03 GAP
NOTE
below cowl vent grille & constant
from < £ to hood rear corners.
Fig. 2C -22--Front End Sheet M etal C hecking-G M odel
Fig. 2 C -23 --F e n d e r Skirt, Dash and Toe P an-P Series
CHASSIS SHEET METAL
Hood surface flush to .06
2 C -1 1
FENDER TO COWL
.07 GAP (Ref)
NOTE
Cowl vent grille
surface flush to .03
below front fender.
LIG H T T R U C K S ER V IC E M ANUAL