Replacing The Smart Card Reader Cable Assembly; Figure 6-6 Removing And Replacing The Smart Card Reader Cable Assembly - Sun Microsystems Sun Blade 100 Service Manual

Smart card reader cable
Cable routing clip
J8 connector
FIGURE 6-6
6.2.10

Replacing the Smart Card Reader Cable Assembly

1. Replace the smart card reader cable assembly as follows (
a. Position the smart card reader cable assembly into the chassis.
b. Close the cable routing clip.
c. Connect the smart card reader cable assembly connectors to the following:
Riser board (J8)
Smart card reader
Note – Ensure that the cable assembly connectors are properly oriented by aligning
the connector keys.
2. If you moved the fan assembly, replace it. See Section 6.4.2 "Replacing the Fan
Assembly" on page 6-17.
3. Detach the wrist strap, replace the system cover, and power on the system as
described in Chapter 9 "Finishing Component Replacement."
6-10 Sun Blade 100 Service Manual • October 2000
Removing and Replacing the Smart Card Reader Cable Assembly
):
FIGURE 6-6