Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
2. Disconnect the secondary IDE cable assembly connector from the following
(
FIGURE 6-5
Secondary hard drive
Riser board (J503: also labeled IDE2)
3. Remove the secondary IDE cable assembly from the chassis.
FIGURE 6-5
6.2.8
Replacing the Secondary IDE Cable Assembly
1. Position the secondary IDE cable assembly into the chassis (
2. Connect the secondary IDE cable assembly connectors to the following:
6-8
Sun Blade 100 Service Manual • October 2000
):
Removing and Replacing the Secondary IDE Cable Assembly
Secondary hard drive
Riser board (J503: also labeled IDE2)
IDE2 (J503)
).
FIGURE 6-5