Advertisement
Quick Start Installation
Step 1 - The Following Wires Must Be Connected!
6 Pin Power Connector
Yellow
Starter Output
Green
Heater Output
Red
12 power Input
Red
12 power Input
Blue
Ignition 1 Output
14 Pin Power Connector
Black
System Ground
Pink
Brake Switch
White
Park Lights
Green/White Hood Pin
Blue/White
Tach Input
Manual Transmissions Only
Violet
(+) Door Input
Green
Black/White
NOTE: Manual Transmissions MUST be set into RESERVATION MODE!
Step 2- Plug-In The Module
Make all wiring connections before connecting the module. The ignition must be in the
OFF position. Plug in the 6 pin connector followed by the 14-pin connector then any
other connectors that were used. When the system is powered up the system will
respond by flashing the park lights and honking the horn (Optional) twice. If this does not
happen, disconnect the module and check that the system has a good ground and that
the ignition wire has no voltage present.
Step 3- Auto Tach Learn
1) Plug in the module. (See above)
**The park lights should flash twice upon power up.
2) Turn the Ignition Key to the ON position. (The Park Lights will turn on).
3) Start the vehicle with the ignition key, The LED's on antenna will come on solid when
proper tach signal is detected*. The Tach Learning process will take up to 36 seconds.
When the system has learned the Tach the park lights flash and the horn (Optional) will
honk twice to confirm Tach Learning**.
Note: The system will flash the park lights seven times if not Tach Learned and the
start button is pressed. The system must be tach learned before remote starting.
* If the LED's do not turn on or flash erratically, A proper tach signal was not detected.
** If the park lights do not flash in auto tach learn mode it may be necessary to connect to
a different tach source. For best results connect the tach wire to the coil pack or to a fuel
injector wire*.
***The ignition 1 input Must be connected to a wire that does Not turn off in the Start
position.
*The Tach wire must be above 2 Volts A/C for proper detection.
***To relearn a tach signal the system must first be reset to defaults. See page 7.***
6
Your Basic Install Is Complete!
(-) Door Input
Park Brake
Installation Guide
Connect To The Vehicles Starter Wire.
Connect To The Vehicles Accessory Wire.
Connect to Constant 12 Volt Power Source
Connect to Constant 12 Volt Power Source
Connect To the Vehicles Primary Ignition.
Connect To Chassis Ground.
Connect To (+) When Brakes Applied.
Connect To (+) Park Light System.
Connect To Hood Pin Switch.
Connect To A/C Tach Source.
Connect this wire to negative door pin switches.
Connect this wire to positive door pin switches.
Connect this wire to the vehicles park brake wire.
Advertisement
