Advertisement
Product Description And Installation
Components
- Control module
- RF Antenna (With Program Switch And LED's)
- 6 pin main harness with dual 30amp power inputs
- Hood pin safety switch
Feature List
- Dual 30amp Power Inputs
- Six button Remote Transmitters
- Engine Idle Mode
- 5 Programable Auxiliary Outputs
- Window Roll-Up/Down Output
- Dual Sliding Door Control
- Programmable Driver's Door Priority Output
- Programmable Dome Light Supervision
- Programmable Starter Kill/ Anti-Grind Protection
- Programmable Passive/Active Starter Kill Output
- Dedicated (-) When Running Output
- Outputs For Pulsed/Latched/Active While Held.
- Door Locks .125s/ .75s/3.0s/Double Unlock.
- Auto Tach Learning With Manual Adjustment Option - (-) During Crank Output
- Programmable Horn Output (5, 10 or 20ms output) - Ignition Auto Locks
Recommended Installation Procedures
Proper Connections - Remote Starters can handle loads of up to 30 amps for
extended periods of time. It is CRITICAL to insure that ALL high current connections are
properly soldered and insulated with quality electrical tape. Failing to insure proper
connections will result in warranty being VOID and can result in a FIRE. The
manufacturer is not responsible for any such damages.
Under Hood Connections - Route the hood pin and tach wires through the firewall
into the engine compartment. Always try to pull the wires through a factory rubber
grommet. If drilling through the firewall, BE CAREFUL. Check for obstructions on both
sides of the firewall. After drilling use a grommet to protect the wires from sharp edges.
Installing the External Long Range Antenna - To insure the best possible
reception, place the antenna in the center of the windshield, behind the rear view mirror.
Before attaching to the glass ensure that the surface is clean and dry. For best results
with range, place the antenna below the tint screen. Run the cable under the head liner
and behind the A-pillar panel. Be careful not to pinch the antenna cable. Plug the
antenna into the BLUE connector on the Control Module.
Mounting The Control Module - Never mount the module in the engine
compartment. Select a location under the dash to install the main module. Be certain
that the module is securely attached and does not obstruct any serviceable areas. Do
not force or jam the module into tight places instead of mounting. The module must be
free from all moving parts such as brake and clutch as gas pedals linkages. Do not
place the module directly in front of a heater vent.
4
Installation Guide
- 6 button Remote transmitter(s)
- 14 pin harness
- 4 pin keyless entry harness
- Install and Owners manual
- Dome Light Supervision
- Turbo Timer Mode
- Remote Panic Feature
- Defrost Activation
- Dual Car Operation
- Fused Park Light Output
- Park Light Diagnostics
- (+/-) Glow Plug detection
- Programable Wait to Start
- (+/-) Park Light Outputs
- Safety Start Mode.
- Run Time 15/30 or 45 minutes
- Safety Start Mode
Advertisement
