Husqvarna Viking Designer Ruby Deluxe User Manual page 78

6. Clear sufficient space around the machine to
accommodate movement of the embroidery arm and
the hoop. Hold the needle thread and press the Start/
Stop button or the foot control. The machine starts
embroidering.
Note: This machine features Automatic Jump Stitch Trim. When
activated the machine trims the top jump stitch threads and pulls the
thread ends to the underside of the fabric. The default setting is on.
To turn it off, go to the SET Menu, Sewing Settings and deselect
Automatic Jump Stitch Trim. Read more about Automatic Jump
Stitch Trim in chapter 3.
If Automatic Jump Stitch Trim is not activated the machine
will stop after stitching a few stitches. A pop-up message
will appear on the screen asking you to cut the thread
end. Cut the thread and press Start/Stop to continue
embroidering.
7. When the first color is completed, your machine cuts
the thread end and stops. A pop-up message appears
asking you to change thread color. Re-thread with the
next color and continue embroidering by pressing
Start/Stop. Hold the thread end. The machine will trim
the top thread end and pull the thread to the underside
of the fabric.
At the end of each color block, the thread is tied off
and the needle thread is cut.
8. When the embroidery is completed, your machine
cuts the top thread and bobbin thread and stops. The
needle and presser foot raise automatically for easy
removal of the hoop.
A pop-up message and sound informs you that your
embroidery is finished. Touch OK to keep the design
loaded and stay in Embroidery Stitch-Out.
6:6